Question 1

I have a double outswing set of closet doors (a left & right hinge). Do I order 1 or 2 "dummy sets" of door knobs? View answer

Asked 4 ´months ago | Emtek Modern Round Knobset w/Square Rosette (Privacy - Round Knob - Satin Nickel - 2-3/8in. Backset)

Question 2

For the extend a hand 16 inch grab bar the spring mechanism peg or knob is it metal or plastic? View answer

Asked 4 ´months ago | Extend-A-Hand 12" (305mm) Folding Grab Bar (Stainless Steel)

Question 3

Do you make a version with projection of less than 1/2 inch? View answer

Asked 4 ´months ago | Designs of Distinction 12-3/4" (324mm) Designer Cabinet Door Drip Edge (Flat Black)

Question 4

Can you confirm this is correct replacement? View answer

Asked 4 ´months ago | Salice Vibo 35 Qt. Single Replacement Waste Container Bin - EACH (Silver/Gray)

Question 5

Does the extend a hand come 16inches with 8 inch projectionn View answer

Asked 4 ´months ago | Extend-A-Hand 16" (406mm) Folding Grab Bar (Stainless Steel)

Question 6

What is the dimension of the post that attaches to the door (Field Enterprise 2" Rectangular Ring pull) View answer

Asked 4 ´months ago | Field Enterprise 2" (51mm) Rectangular Ring Pull (Satin Brass)

Question 7

How can I acquire a tiny barrel key for an antique clock? I have dimensions. View answer

Asked 4 ´months ago | CLOSEOUT SPECIAL! - Compx National Warded Barrel Key Blank - EACH

Question 8

for the narrow single trash bin pull out - is the width adjustable? The current installation tracks are 9 1/2" View answer

Asked 4 ´months ago | Kessebohmer Wastebin Pullout Frame - Chrome - Wide Double (Frame Only, Bins Sold Separately)

Question 9

just to make sure that a "Dummy Set" order implies to two item? View answer

Asked 4 ´months ago | Emtek Modern Aston Door Leverset w/Modern Rosette (Dummy Set - Satin Brass)

Question 10

Is the TOTAL open height 10-3/4", or does it RAISE by that much and the total open height 14-3/16"? View answer

Asked 4 ´months ago | Selby Spring-Assist, Lift-Top Coffee Table Mechanism - EACH (Black Epoxy)

Question 11

For the SGS-BB1000-4. How do you remove the pin? Is there a template or pattern dimensions for the screw holes? View answer

Asked 4 ´months ago | SGS Commercial Duty 4" x 4" Ball-Bearing Hinge - Square Corner - EACH (Lacquered Oil Rubbed Bronze)

Question 12

Is this solid? View answer

Asked 4 ´months ago | Top Knobs Asbury 1-3/8" (35mm) Flat Top Cabinet Knob (Brushed Satin Nickel)

Question 13

Orientation View answer

Asked 4 ´months ago | Handcrafted Hardware 2-1/8" (54mm) x 1-1/2" (38mm) Latch (Antique Brass)

Question 14

This hardware set is for 3 shelves, I only need hardware for one or two View answer

Asked 4 ´months ago | Century Components Contender Series 3-Shelf Lazy Susan Hardware Only

Question 15

is the Schwinn 2389/480-SN 480mm CC appliance pull in satin nickel strong enough for a sub-zero fridge? View answer

Asked 4 ´months ago | Schwinn Design 2389/480 18-7/8" (479mm) Center-to-Center Appliance Pull (Satin Nickel)

Question 16

Schlage fe595 change code View answer

Asked 4 ´months ago | Schlage FE575 Plymouth Electronic Keypad Entry with Auto-Lock - Elan Lever Trim (Satin Chrome - Adjustable Backset)

Question 17

Is this unlaquered brass? View answer

Asked 4 ´months ago | Epco 5" (128mm) Center-to-Center Solid Brass Cabinet Wire Pull (Polished Brass)

Question 18

do you offer any additional lengths in this finish and diameter View answer

Asked 4 ´months ago | 24" (610mm) Solid Brass Tubing - 1-1/2" (38mm) Diameter - (Unlacquered)

Question 19

I'm ordering 14 - will one key work in all 14? View answer

Asked 4 ´months ago | National 1-3/16" Disc Tumbler Cylinder Cam Lock - Keyed Alike #413 (Antique Brass)

Question 20

How do I fix a sensor so that the light doesn't stay on all the time. View answer

Asked 4 ´months ago | Hafele Loox LED Motion Detector w/Adjustable Range, Modular Design - EACH (White/Gray/Black)

Question 21

How do I select the proper strike plate? Are there ootions? View answer

Asked 4 ´months ago | Emtek Old Town Clear Glass Door Knobset (Dummy Set - French Antique)

Question 22

what size screws are included for mounting? View answer

Asked 4 ´months ago | Sugatsune 303 Stainless Steel 2" (51mm) Utility Hook (Polished)

Question 23

Are the baskets removable View answer

Asked 4 ´months ago | Rev-A-Shelf 22-1/8" (562mm) W Double Top-Mount Vanity Hamper Pull-Out w/Soft-Close

Question 24

Can this slide be used with both framed and unframed openings? View answer

Asked 4 ´months ago | Grass Dynapro 3-D Concealed Soft-Close Full-Extension Drawer Slide - PAIR

Question 25

Can you use these one 3/4" drawer thickness? View answer

Asked 4 ´months ago | Blum 18" (457mm) MOVENTO 769. Heavy-Duty Concealed Soft-Close Full-Extension Drawer Slide, Frameless - PAIR

Question 26

Do you have this Emtek EMT-462222-L-FBS-LH-2.38 for thicker doors It saysFor 1-3/8 to 1-3/4in thick need 2.25 in? View answer

Asked 4 ´months ago | Emtek Wrought Steel San Carlos Entryset (Single Cylinder - San Carlos Lever - Flat Black - Right - 2-3/8in. Backset)

Question 27

Can you confirm that PEM-P51B17 is identical as your diagram including the bends in the metal ? View answer

Asked 4 ´months ago | Pemko Spring Bronze Weatherstrip - 17ft. Roll (Bronze/Brass)

Question 28

My door frame is 14 3/4 which looks to be too small for this model. Do you have a smaller size that might work? View answer

Asked 4 ´months ago | Sugatsune SLUN Lapcon Vertical Swing Lift-Up (Lid Stay) Mechanism - PAIR (Nickel)

Question 29

Was wondering if you had the other half of the kitchen cabinet hinge CS725/00 View answer

Asked 4 ´months ago | Grass Nexis (Mepla CS7251/00) 0MM Face Frame Base Plate - EACH (Screw-in, Steel)

Question 30

Am i able to order this as an 18 in appliance pull? View answer

Asked 4 ´months ago | Atlas Homewares Sweetbriar Lane 12" (305mm) Center-to-Center Appliance Pull (Matte Black)

Question 31

Does it come in black? View answer

Asked 4 ´months ago | Sugatsune Sliding Door Privacy Latch with Indicator - EACH (Satin Stainless Steel)

Question 32

is pin removable View answer

Asked 4 ´months ago | Schaub and Company Adjustable Solid Brass 2-1/2" (64mm) Flush/Full Inset Non Mortise Ball Tip Hinge - EACH (Polished Chrome)

Question 33

do you sell the nuts that match this screw? View answer

Asked 5 ´months ago | Base For Custom Cabinet Knobs & Pulls - 5/8" (16mm) (Polished Brass)

Question 34

Hole Separation View answer

Asked 5 ´months ago | Hafele Floor Mounted Door Guide - EACH (Grey Plastic)

Question 35

I have several pocket doors that are 2'-6" wide. Does the "silent system" work on a door that narrow. View answer

Asked 5 ´months ago | Top Line Grant HD Series Low-Profile Ball-Bearing Carrier Set - (325lb.)

Question 36

do you have this in a 32 inch width View answer

Asked 5 ´months ago | Seachrome 42in. x 20in. Bench Style Folding Shower Seat w/Swing Down Legs and Lift Assist (Stainless Steel/White Phenolic)

Question 37

Do you have 3” wide View answer

Asked 5 ´months ago | Designs of Distinction Finishing Touches 1-1/4" (32mm) x 72" (1829mm) Decorative Aluminum Strapping - Chrome

Question 38

minimum depth of cabinet for LeMans 50 View answer

Asked 5 ´months ago | Kessebohmer LeMans II 50 - 18in. Corner Pullout 2-Shelf Set - Right Hand Swing (Champagne/Maple)

Question 39

is the total length 72" View answer

Asked 5 ´months ago | Emtek Select 36" (914mm) Center-to-Center Smooth Appliance Pull (Satin Brass)

Question 40

Size of screw for View answer

Asked 5 ´months ago | Blum Expando 5mm x 11.5mm Split Dowel - EACH

Question 41

Do these plastic back supports also fit the kv 181 bracket? View answer

Asked 5 ´months ago | Knape and Vogt Back Support for the 180 Brackets - EACH (Clear)

Question 42

anyway to get a black base with glass ball knob View answer

Asked 5 ´months ago | Lewis Dolin 1-1/8" (29mm) Glass Ball Cabinet Knob (Transparent Clear/Oil Rubbed Bronze)

Question 43

Does this 36” wide threshold fit a 36” Door View answer

Asked 5 ´months ago | THH 7-3/4" (197mm) x 36" (914mm) Adjustable Oak Top Door Sill - EACH (Unfinished Oak/Dark Bronze)

Question 44

Would the HES2S-150-A-110-BL work for an out-swing door? View answer

Asked 5 ´months ago | Sugatsune 3-Way Adjustable Surface Mount Concealed Hinge for 1-3/8" (35mm) Min. Thick Doors - EACH

Question 45

Do you have this in polished chrome in a privacy handle View answer

Asked 5 ´months ago | Brass Accents Salem Low Profile Door Leverset

Question 46

What is the base width? Are dimensions available for this handle that’s 12” on center? View answer

Asked 5 ´months ago | Emtek Tuscany Bronze 12" (305mm) Center-to-Center Fluted Fixed Appliance Pull - (Flat Black)

Question 47

how do i configure the required opening and hardware to cover an opening 60" wide, with a pair of doors on each sid View answer

Asked 5 ´months ago | Sugatsune 16" (406mm) Pocket Door System w/Soft-Close, for Inset Doors (M-Type)

Question 48

Is this hinge rated for exterior use? Can it be powder coated ? View answer

Asked 5 ´months ago | PBB Double Acting Gravity Pivot Set with Hold Open Function- For Louver Doors - (Zinc)

Question 49

C176AE9 View answer

Asked 5 ´months ago | Salice Silentia+ 105° Hinge - EACH (Full Overlay, Silentia/Soft Closing, Rapido Mount)

Question 50

When open, will the bottom of the door clear the top of the cabinet opening? View answer

Asked 5 ´months ago | Sugatsune SLUN Lapcon Vertical Swing Lift-Up (Lid Stay) Mechanism - PAIR (Nickel)

Browse by Topic

Tools