To reset or change the code on your Schlage FE575 Plymouth Electronic Keypad Entry, you’ll need to use the default programming code that came with the lock. Here’s a step-by-step guide:
-
Locate the Programming Code:
- The default programming code is usually printed on a sticker on the back of the keypad assembly. You may need to remove the lock from the door to find it if it’s not in your user manual.
-
Enter Programming Mode:
- On the keypad, enter the six-digit programming code. This will cause the Schlage button to flash orange three times and beep three times.
-
Enter the Code to Add or Delete User Codes:
- After entering programming mode:
- To add a new user code: Press
1and then enter the new four-digit user code you want to set up, then press the Schlage button again to save. Repeat this process to add more codes. - To delete a user code: Press
2, then enter the code you wish to remove, and press the Schlage button again.
- To add a new user code: Press
- After entering programming mode:
-
Confirm the Changes:
- To test the new code, lock the door and try to unlock it with the code you added.
-
Factory Reset (if needed):
- If you need to completely reset the lock to factory settings, remove the battery, press and hold the Schlage button while reconnecting the battery, and then release the button once the battery is connected.
If the above steps don’t work or you can’t locate the programming code, you might need to contact Schlage customer support for further assistance.
